A Christian Owned Corporation

You have 0 item in your cart

You have no items in your shopping cart.

Subtotal: $0.00

Bowl Removal Bits

Bowl Removal Bits

If you fabricate Solid Surface sooner or later you are going to find yourself removing a bowl from a top. With a bowl removal bit the job can be done saving either the bowl or the top. If you are planning to save the bowl you simply set the depth of cut to the top of the bowl and make your cut. It's best if you support the bowl while you are cutting.

If you plan to save the deck I would recommend you set the bit just below the bottom of the deck and make an initial cut. Reset the bit to shave of a thin, final layer of the deck. By doing this you will end up with a nice clean area to mount your bowl.

Grid  List 

Set Descending Direction
per page

Grid  List 

Set Descending Direction
per page