A Christian Owned Corporation

You have 0 item in your cart

You have no items in your shopping cart.

Subtotal: $0.00

Trizact Dicsc

Produced with 3Ms new micro replication technology, this film backed abrasive ensures a fast, consistent cut rate through the long life of the abrasive. Fantastic results on solid surface composites, plastics and glass defect repair. Used for damp finishing of solid surface, glass and acrylic materials.

Sanding Steps for Solid Surface Materials:
 

MATTE FINISH
OPTIONAL PRE-STEP 3M 366L 100 micron
(if necessary to level rough surface)
STEP 1 3M 268XA A35 (Green)- Use dry or with light to
medium water mist. Finish with 3M 268XA A10 - light to medium water mist or 3M 7447 Scotch-Brite pad

SEMI-GLOSS FINISH
OPTIONAL PRE-STEP
 3M 366L 100 micron
(if necessary to level rough surface)
STEP 1 3M 268XA A35 (Green)- Use dry or with light to medium water mist. Finish with 3M 268XA A10 - light to medium water mist or 3M 7447 Scotch-Brite (Maroon)pad
STEP 2  3M 268XA A10 (Blue)- light to medium water mist. Finish with 3M 268XA A5 - light to medium water orist
3M 7448 Scotch-Brite pad (Grey).

HIGH-GLOSS FINISH
OPTIONAL PRE-STEP 3M 366L 100 micron
(if necessary to level rough surface)
STEP 1 3M 268XA A35 - light to medium water mist
STEP 2 3M 268XA A10 - light to medium water mist
STEP 3 3M 268XA A5 - light to medium water mist
STEP 4 3M 568XA - medium to heavy water mist
Repeat step 4 if necessary

Rinse debris from Trizact disc
after each use, and wipe surface
clean fo l l owing each step to minimize
contamination scratches .