Table Mount Air Hammer w/ Super Soft Tip

Pressure from the workpiece activates this high quality pneumatic tool. The cycle stops immediately when the workpiece is removed. The AH-15-TM will deliver over 1000 hammer blows per minute. Start the end of the tee molding into the kerf with finger pressure, push it against the hammer tip and advance the work piece and tee molding across the hammer tip as fast as the molding is set. Operating on less than 3cfm, this tool applies T-Molding ranging in width from 1/8" to 2" and can be worked in either direction. Mounts quickly to any flat worksurface. Fitted with a Super Soft tip.